Articles > ROLLER CUTTING (CHOPPER) in Ukraine from the manufacturer
10/15/2019
ROLLER CUTTING (RESIDUES CHOPPER)
in Ukraine from the manufacturer
Work on the ground requires simple, reliable and inexpensive agricultural equipment. It is now difficult to imagine the activities of a successful farm without a chopping roller. It is easy to use and inexpensive to purchase.
In the meantime, there is no need to know about it. ”
Water-filled hydraulic chopping roller-grinder KP-6-560P is intended for crushing plant residues after sunflower, corn, rapeseed, grain crops, vegetables, etc. Plant residues are crushed and remain on the soil surface (partial mulching), and this provides additional loosening, mixing and leveling of the soil.
MAIN CHARACTERISTICS
CUTTER ROLLER (CHOPPER):
• capture width - 6 m
• knife diameter - 560 mm
(from other manufacturers up to 460 mm);
• pipe diameter - 325 mm
(from other manufacturers up to 220 mm)
• weight - up to 2250 kg
(from other manufacturers up to 1700 kg);
• the knife is made of steel 65 G;
• the knife is sharpened using plasma cutting technology, which
provides hardening of the knife edge to a depth of 7 mm;
• double-sharpened knives.
In the meantime, there is no need to know about it. ”
Additional equipment for the chopping roller (shredder):
execution with staggered knives is possible;
the roller is equipped with cable guides, cable diameter 10 mm;
the roller frame can be equipped with ring-toothed and
ring-spur roller, so you can purchase a section of the roller and, depending on the need, use a roller of different configuration;
it is possible to add 150 liters of water to each section, which will increase the weight of the roller by 450 kg.
It is important to understand that there are still a lot of parameters that should be analyzed before buying a roller.
For example, at a shredder roller from "Apostolovagromash":
• the frame of the chopping roller is made of 120x120x8 pipe
(wall thickness 8 mm) (for other manufacturers 100x150x6, wall thickness 6 mm);
• In the 120x120 pipe, the wing pin mounting bushings increased to 80 mm are installed;
• wing toe made of heat-treated 45 steel, toe diameter 50 mm
(from other manufacturers 40 mm) ;
• the cheeks on the wing are made of 25 mm thick sheet, respectively, there are increased
along the length of the sleeve to hold the wing pin (other manufacturers use a 16 mm sheet) ;
• half-shafts for transport wheels are made of 80 mm circle and welded into the wing struts
(from other manufacturers from a circle of 60 mm and screwed with nuts, which weakens the structure) .
In the meantime, there is no need to know about it. ”
We hope that after reading the article it will be easier for you to make your choice and buy a chopping roller (shredder of plant residues) cheaply with factory quality and a guarantee
In the meantime, there is no need to know about it. ”
Articles > ROLLER CUTTING (CHOPPER) in Ukraine from the manufacturer